Laboratories:
- Advanced Measurements Laboratory
- Measurement of Resistance, Inductance and Capacitance using Bridge Circuits setup
- Measurement of Sequence Impedances of Synchronous Machines setup
- Instrumentation Amplifier
- Phase angle Measurement - kit
- Data Acquisition through Virtual Instrumentation setup
- Strain and Temperature measurement with NI-ELVIS.
- Power Quality Measurement - Power Quality Analyser
- Electronic Devices and Circuits
- Digital Spectrum Analyzer
- Logic Analyzers
- Waveform Processors
- Oscilloscopes and Measuring Instruments
- Analog Discovery Kits
- Computer based data acquisition system
- Mixed signal analysis workbench(software and hardware)
- Digital Electronics Laboratory
- Design of Logic and Arithmetic Circuits setup
- Registers.
- Design of Counters.
- Encoder and Decoder.
- Multiplexer and De-multiplexer
- PAL / PLA implementation kit.
- Combinational and Sequential logic circuits using HDL programming.
- Microprocessor and Microcontroller Laboratory
- 8085 Microprocessor Kit
- Kits based on ARM processor kit Embest IDE with stepper motor
- PIC microcontroller
- DSP based speed control of five phase induction motor
- Computer Simulation Laboratory
This lab is equipped with several software and hardware to train the students through simulation.
- PSPICE version 10.0
- LabVIEW 7.1
- DigSILENT software
- Xilinx Integrated Synthesis Environment Foundation Series
- MATLAB – Simulink Software
- Embest Integrated Development Environment for ARM and PIC Microcontroller
- Code Blocks in C software
- SCILAB software
- Power System Laboratory
- Three Phase Fault Analyser
- Differential protection of 3 phase transformer
- Generator protection system
- Generating station setup
- 400 kV HVAC Transmission line model
- Measurement and Protection section
- Receiving station setup
- RLC Loading unit
- Dynamic Grid fault simulator
- SCADA based transmission line analyzer
- Smart Grid Simulator
- Smart Grid Technology Laboratory
- Grid supply unit
- AC transmission and distribution setup
- Generating station setups
- 3 Phase Solar Grid connected Inverter
- 3 Phase modular multilevel Inverter
- Power Electronics and Drives Laboratory
- SCR, TRIAC, MOSFET and IGBT - Kits
- Rectifier Kits
- Buck, Boost and Buck-Boost converter - Kit
- Single phase PWM inverter kit
- Series inverter kit
- BLDC motor speed control system
- AC Machines Laboratory
- Induction Motor (10 HP, 7.5 HP and 2.5 HP)
- 3 phase Synchronous Motor
- 3 phase Alternators
- Single phase alternator
- Autotransformers
- Single phase and three phase transformers
- Motor Testing Laboratory
- Motor Test Rigs with Dynamometers and Load sensor
- Eddy current Dynamometer and Load Cell
- Power Analyzer
- Motor Testing Software with Personal Computer
- Power Supply unit
- Hand Held Resistance Meter
- Hand Held Infrared temperature Tester
- Leakage Current Tester
- Hand Held Vibration Meter
- Hand Held Sound Level Meter
- Hydraulic Motor Lifting Manual Stacker
- Equipment to measure and plot temperature rise for different duty cycle
- Induction Motors
- BLDC Motor and Fractional HP DC Motor
- DC Machines Laboratory
- Compound Motor – 3.5 HP
- Series Motor – 3.5 HP
- Shunt Motor – 5 HP
- DC Generator (self and separately excited)
- Resistive Load setup – 5 kW
- Control Systems Laboratory
- Digital position control system
- Programmable Logic Controller experimental setup
- Centre of Excellence – Alternate Energy Research Laboratory
- Solar Grid-tied training system
- Solar PV Emulator
- Power Quality Analyzer
- Weather Monitoring Station
- Wind Turbine Emulator
- Solar System Analyzer
- Smart Grid Simulator
- Solar PV Performance Analyzer
- EMI/ EMC bundle
- Smart Grid system and Accessories
- Software Defined Power Electronics Real Time Controller
- Data logging system for Domestic Wind Power
- Experimental setup for DFIG based wind turbine and accessories
- Three phase STATCOM setup
- Power Converter kits
- Shunt Active Filter using FGPA & VSI setup
- Real time simulator setup
- Numerical Relay Development Environment board
Patent
- Novel Design and Construction of 8.4 kW- Dual axis solar tracking system driven by a Low Powered Drive – US Patent Number : US 10,340,841 B1 dated : 02.07.2019.
1.Solar Module
2. Solar Powered Boat
3. Modem W Antenna
